10
3)
Remove Return Air Cover and Ceiling Template
from the 3105007 or 3105935, return air cover
kit carton.
4)
Remove Parts Package, Electronic Box and
Thermostat from Electronic Kit, Carton No.
______________.
5)
Locate 1/4" unit mounting bolts in the parts
package.
6)
Take the ceiling template and hold up to the 14"
opening. Be sure the solid end faces the rear of
the RV.
7)
Start each mounting bolt through the ceiling
template and up into the unit base pan by hand.
EVENLY TIGHTEN MOUNTING BOLTS TO A
EVENLY TIGHTEN MOUNTING BOLTS TO A
EVENLY TIGHTEN MOUNTING BOLTS TO A
EVENLY TIGHTEN MOUNTING BOLTS TO A
EVENLY TIGHTEN MOUNTING BOLTS TO A
TORQUE OF 40 TO 50 INCH POUNDS
TORQUE OF 40 TO 50 INCH POUNDS
TORQUE OF 40 TO 50 INCH POUNDS
TORQUE OF 40 TO 50 INCH POUNDS
TORQUE OF 40 TO 50 INCH POUNDS
This will compress the roof gasket to approxi-
mately 1/2". The bolts are self locking so over
tightening is not necessary.
8)
Install wood screw in each end of ceiling tem-
plate. This insures a tight fit of return air cover
to ceiling.
Pull Conduit
Down
Gasket
Wires from
power
source
Thermostat
Cable
Screws
Rubber Gasket
Finger-Tight
40-50
IN. L BS.
To Fr ont of V ehicle
B.
B.
B.
B.
B. INSTALLATION OF DIVIDER PLATE
INSTALLATION OF DIVIDER PLATE
INSTALLATION OF DIVIDER PLATE
INSTALLATION OF DIVIDER PLATE
INSTALLATION OF DIVIDER PLATE
1)
Measure the ceiling to roof thickness:
a. If distance is 2.00" - 3.75", remove perforated tab
from Divider Plate.
b. If distance is 3.75" - 5.50", remove no tabs.
2)
Remove the backing paper from double sided tape
located on Ceiling Template.
3)
Place Divider Plate up to bottom of Air Conditioner
base pan firmly. The foam tape on the divider plate
must seal to bottom of base pan.
Note:
Note:
Note:
Note:
Note:
The adhesive on double sided tape is
The adhesive on double sided tape is
The adhesive on double sided tape is
The adhesive on double sided tape is
The adhesive on double sided tape is
extremely sticky. Divider Plate must be properly
extremely sticky. Divider Plate must be properly
extremely sticky. Divider Plate must be properly
extremely sticky. Divider Plate must be properly
extremely sticky. Divider Plate must be properly
positioned before pressing in place.
positioned before pressing in place.
positioned before pressing in place.
positioned before pressing in place.
positioned before pressing in place.
4.
With slight pressure then push divider plate against
exposed double sided tape on ceiling template.
5.
Locate 1/8" x 7" x 18" self-adhesive insulation supplied
with the Return Air Kit.
6.
Remove the backing paper from the insulation and
carefully stick onto the ceiling template divider panel.
2.00"-3.75"
Backing P aper
Push Divider Plate firmly
onto T emplate
