4
Once the system is completely installed, do a system reset:
1. Make sure the CCC 2 thermostat is in the OFF mode. See section, “C. Quick
Reference To Control Buttons” on page (5).
2.
Simultaneously press and hold the
MODE
and
ZONE
buttons. See section, “C.
Quick Reference To Control Buttons” on page (5).
3.
The LCD will display “IniT” and all available zones.
4.
Release the
MODE
and
ZONE
buttons.
5. Press the
ON/OFF
button to exit system set up.
6.
The furnace ON/OFF temperature differential should be set at this time. For
further information on furnace mode differential setting, see section, “F. “FURN”
/ “AQUA” - Furnace Or Aqua (Hydronic) Heating Mode” on page (11).
Any time a system reset occurs, the factory default settings are restored. See table,
“Factory Preset Settings” on page (4).
In the unlikely event of CCC 2 system memory loss or dip switch setting change, the
CCC 2 thermostat will require a system reset. For system reset procedure, see main
heading, “System Reset Procedure” on page (19).
Your Dometic CCC 2 thermostat has been pre-programmed. Review settings below
and adjust the settings to your personal comfort level.
Any time the CCC 2 is in an idle stage (not illuminated) you will need to wake it
up by pressing any button on the CCC 2 before it will recognize a new setting
attempt.
Factory Preset Settings
Factory Preset Settings Each Zone
All Zones
Program “1”
Function
Setting
Function
Setting
Time of Day (Clock)
— — —
Heating
68 °F / 20 °C
Each Zone
Cooling
72 °F / 22 °C
Automatic
70 °F / 21 °C
Heating
68 °F / 20 °C
Fan Speed
Auto
Cooling
72 °F / 22 °C
Mode
Off
Automatic
70 °F / 21 °C
Time
8:00 AM
Fan Speed
Auto
Program “2”
Mode
Off
Heating
68 °F / 20 °C
Cooling
72 °F / 22 °C
Automatic
70 °F / 21 °C
Fan Speed
Auto
Mode
Off
Time
10:00 PM
ABOUT YOUR NEW THERMOSTAT
