ASB4 manual │ version 1
- 2022
Page:
10 from 14
Adjustment
Setting the servos
The tuning of the servos on the ASB4 has been greatly improved over its predecessor, the ASB. You can
now select the servo you want to program, you can skip steps if necessary and you can see which step
you are working on by means of the LEDs.
The LEDs have multiple functions:
LED Power: Supply voltage is OK LED Program:
ASB is in programming mode
Now the Led's X1 to X4 have several functions. During active
operation, i.e. not in program mode, they indicate the status of
the relay. If the LED lights up, this means that the corresponding
relay is also active. This way you can check the state of the circuit
during operation.
In all cases: X1:
Servo 1
X2: Servo 2
X3: Servo 3
X4: Servo 4
To program, press the centre button marked "enter" for 3 seconds. To end the
programming function, ensure that the LEDs X1 to X4 are extinguished to get to the
"End" position and press the "enter" button again for 3 seconds. The red LED will then
extinguish and the ASB is set to active mode.
If you are in the programming mode, the red LED is on, you can use the "plus" and "minus" buttons to
choose between LED X1, X2, X3 or X4. You can select to edit Servo 1, 2, 3 or 4 respectively. As soon as
you go in the right direction past X4, or in the left direction past X1 you will notice that all X leds are
extinguished. This is the "End" position, with which you can leave the programming menu.
So there are 5 modes to choose from:
X1 on: Servo 1
X2 on: Servo 2
X3 on: Servo 3
X4 on: Servo 4
X1 to X4 off: Quitting programming mode
If you wish to proceed to the next step, use the "Enter" key. To ensure that you do not confirm an action
unintentionally, we have built in a delay of at least 1.5 seconds for the enter button to be pressed. Each
subsequent step is visually confirmed by the brief extinction of the red and orange LEDs.
