[email protected]
www.dompneumatics.com
Page 1: ...e of 90 psi and an air flow according to specification 3 Drain the compressor air tank daily Water in the air line will damage the tool 4 Clean the compressor air inlet filter weekly 5 Line pressure should be increased to compensate for unusually long air hoses over 8 mts The minimum hose diameter should be 1 4 I D and fittings must have the same inside dimensions 6 Keep hose away from heat oil an...
Page 2: ...F SANDING PAD 1 Disconnect the tool from the air supply 2 Rotate by hand the orbit and find the installation hole of the orbit wheel from the hole of the front sleeve Then insert the rod into the installation hole Hold the rod firmly while releasing sanding pad at counter clockwise Re mount a new sanding pad at clockwise by still holding the rod firmly Make sure the sanding pad is mounted onto the...
Page 3: ...dompneumatics yahoo com www dompneumatics com ...
