Rocker Pad (Single, Double) for ZigBee Green Power
Installation Guide
Models: ESRPZ, EDRPZ
Package Contents
Product Description
Self-powered wireless Rocker Pads provide a flexible and conve
-
nient interface for switching, dimming and controlling electrical
loads. Energy generated by pressing a rocker pad is harvested
and used for RF communications with ZigBee 3.0 devices sup
-
porting ZigBee Green Power telegrams.
Single and Double Rocker pads can be surface mounted or
installed flush over an existing wall box.
Features Include:
▪
User interface for switching, dimming (when used with a
dimmable controller) and more.
▪
Harvests energy from linear motion - no batteries.
▪
Transmits unique IEEE 802.15.4 / ZigBee Green Power mes
-
sage each time pressed or released.
Specifications
Power Supply Mechanical energy harvesting
(power is generated by the motion of
pressing the switch)
Transmission Range 50 ft. (15 m)
RF Communications IEEE 802.15.4 / ZigBee Green Power
Dimensions Single: 4.95” H x 3.21” W x 0.74” D
(126mm x 82mm x 19mm)
Double: 4.95” H x 4.52” W x 0.72” D
(126mm x 115mm x 18mm)
Weight Single: 3.9 oz (112g)
Double: 5.3 oz (150g)
Environment • Indoor use only
• 14° to 104°F (-10° to 40°C)
• 20% to 95% relative humidity
(non-condensing)
Agency Compliance FCC, IC
Planning
Take a moment to prepare and ensure optimal communications
with other system components, and for user convenience.
▪
Pick a convenient location, perhaps near a door where oc
-
cupants enter and exit
▪
Consider the construction materials in the space and ob
-
stacles that may interfere with RF signals
Installing
1. Decide where you want to mount the rocker pad. The stan
-
dard height for wall switches is 49” or 125 cm on center.
2. Remove the wall plate from the rocker pad assembly.
3. Decide which of the two installation options is appropriate.
A. Surface Mounted Installation
i.
Using a level and a pencil, lightly mark 2 small dots to
align the top edge of the mounting plate.
ii.
Mark the mounting screw drill points.
iii.
iv.
Drill holes for the wall
anchors with a 3/16” drill
bit and insert wall
anchors.
v.
Insert the top screw(s)
loosely and level the
back plate.
vi.
Insert the bottom screw(s),
and then hand tighten
the top screw(s).
vii.
Attach the wall plate on
top of the rocker pad
using the two screw holes.
NOTE: For proper
assembly, make sure to
align the “top” labels
on the rocker pad and wall plate
estimated time: 10 minutes
TOP
TOP
TOP
TOP
TOP
TOP
TOP
TOP
Tools Required
Page 1
.74”
18.84mm
.72”
18.34mm
3.21”
81.76mm
4.52”
114.99 mm
4.95”
125.76mm
4.95”
125.76mm
▪
Rocker pad
▪
Wall plate
▪
Screws and wall anchors
▪
Power drill, 3/16” bit
▪
Screwdriver
▪
Leveling tool
© 2016 EnOcean GmbH
