30
0
31
0
S2
S1
30
0
31
0
S2
S1
30
0
31
0
S2
S1
310 MHz
310 MHz
- (8 dip switch)
300 MHz
- (10 dip switch)
- (10 dip switch)
Back of
Keypad
a. Remove the access door on the top back of the keypad by sliding the door
in the direction of the arrow. (see Figure 1)
b. Locate the frequency switches on the top of the electronic board located
inside of the access door. (see Figure 2)
3. SET FREQUENCY JUMPER
a. Determine the operating frequency you will use on your keypad installation.
This keypad can operate at either 300 MHz or 310 MHz. At 300 MHz the keypad is
compatible with the Hive 300/310 receiver and all 300 MHz receivers with 10 dip
switches. At 310 MHz the keypad is compatible with the Hive 300/310 receiver,
and all 310 MHz receivers with 8 dip switches and 310 MHz receivers with 10 dip
switches. (see S1 and S2 on Figure 3)
3
Figure 3
Figure 1
Figure 2
jumper
in place
access
door
300
M
H
Z
310
M
H
Z
S2
S2
S1
310MHz
8 dip
10 dip
dip
switch
selection
jumper
300MHz
4. SET DIP SWITCHES
a. Set the DIP switches of the keypad to match the DIP switch settings of the
receiver, or a functioning transmitter. (see Figure 4)
b. Enter then the 4 digit PIN on the keypad, and then press # to activate the
receiver. If you just purchased the keypad, the factory default 4-digit PIN is 1234.
So please enter 1-2-3-4 #. If the receiver does not operate, reverse the keypad
DIP switches, and re-enter 1-2-3-4 #.
