BC 2002
User Manual www.dolphindispensers.co.uk
Periodic cleaning of the unit is recommended to ensure optimum performance.
Cleaning and Maintenance
Disconnect the electrical supply.
Remove the two cover-mounting screws.
Remove the cover.
Clean all dust lint from the interior of the dryer.
Replace the cover. Do not over tighten the screws.
Wipe the cover with a damp cloth and mild
cleaning solution. Do not Soak. Never use
abrasives to clean the cover.
Recommended mounting heights
- from bottom edge of dryer above finished floor (AFF)
Men
Women
Children 4-7 years
Children 8-10 years
Children 11-13 years
Children 14-16 years
Handicaped
(38")
960 mm
(32")
812 mm
(34")
860 mm
(36")
910 mm
(38")
960 mm
(34")
860 mm
(40")
1000 mm
‘Unit should be mounted to give no less than 300mm
clearance from the bottom of the unit to the nearest
surface below’
Heater Element Switch ON/ OFF
Warm aır speed adjustment
SW.FOR HEATER
VR. FOR AI R SPEE D
Sensor range adjustment
VR. FOR SENSOR
1.Switch off the power, loosen the cover screws and
remove the cover.
2.Use small Philips head screwdriver or plastic flat blade
probe to turn VR shaft
.
C
lock-wise [CW] to increase
power to maximum
(+)
,
turn tool gently [CCW] to
reduce power as required
(-) .
1.Switch off the power, loosen the cover screws and
remove the cover.
2.Adjust the heater switch on the PCB with a small
plastic or wood flat blade probe.
2-1. Slide the switch to "ON" :Enables heater on.
2-2. Slide the switch to "1" :Disables heater.
2.Clockwise: Increases the sensing range(+)
3.Counterclockwise
:
Decreases the sensing range(-)
4.DO NOT OVERTURN!
1. The range is 4" to 9” [100 mm to 230 mm],
standard setting is 6" [170 mm ± 20 mm ]
All manuals and user guides at all-guides.com
all-guides.com
