NOT-PROLITE-00
NOT-PROLITE-00
WARNING
This manual contains vital and essential information,
in order to avoid electrical shocks, overcharging
or irreversible damage to the material. The owner
should read and understand this document before
operating the charger.
This device is not intended for use by persons
(including children) with physical, sensory or mental
disability, or by persons lacking experience or
knowledge, unless they have received from a person
in charge of their safety adequate supervision or
preliminary instructions on how to use the device.
For any question, contact your dealer.
Installation
T
his charger is suitable for use in marine engine
compartments, and near fuel tanks.
Do not install the charger near a heat source.
It should not be installed in an airtight or badly
ventilated area.
Leave at least 10cm / 3inches clearance around the
charger for proper ventilation.
Install the charger in a vertical position to create
an optimal ventilation. Note that wirings are at the
bottom of the charger.
All electrical connections to and from the charger
must remain accessible all the time.
The charger should not be exposed to water.
In order to maintain watertightness, it is strictly
forbidden to dismantle the charger and/or to modify
the casing and/or wirings in any way.
The charger must be correctly and strongly fixed.
This device is not a toy and must be kept out of the
reach of children.
Connections
According to the model, the charger is set to be
connected to a monophase network 230V 50Hz or
115V 60Hz (refer with technical specifications).
The installation to which the charger is connected
must comply with the standards currently enforced in
the country of use.
In order to protect the occupants, the main power
supply access must be attached to a differential
circuit breaker (refer with technical specifications).
For safety reason, the green / yellow wire of the
power cord must strictly be connected to the earth of
the installation.
The cable N°1 of power cord must be connected to
the LINE or PHASE, the N°2 to the NEUTRAL.
To prevent overheating, ensure the correct tightening
of the connections.
Each access or wire connected to the battery
must be protected with a fuse (refer with technical
specifications).
Output batteries must be connected to the charger
before its power-on.
This device complies with enforced standards
regarding emitted interferences and disturbances of
external origin.
Regarding electromagnetic interferences, ensure that
other materials used are compatible with this device
in order to avoid irreversible damage.
WARNING
