Configurable Safety System SAFEMASTER PRO
82
0265525 / 16.05.19 en / 101A
EXAMPLE OF A PROJECT
This Example shows an example of a project in which the UG 6911.10 unit only is connected to two safety blocks
(E-GATE and E-STOP). The UG 6911.10 inputs (1, 2, and 3) for connecting the contacts of the safety components
are shown on the left, in yellow. The SAFEMASTER PRO outputs (from 1 to 4) are activated according to the
conditions defined in E-GATE and E-STOP (see the E-GATE - E-STOP sections).
By clicking on a block to select it, you enable the PROPERTIES WINDOW on the right, which you can use to
configure the block activation and test Parameterss (see the E-GATE - E-STOP sections).
At the end of the project design stage (or at intermediate steps) you can save the current configuration using the
icon
on the standard tool bar
.
Project validation
If the validation is successful, a sequential number is assigned to the input and output of the project.
Then, this number is also listed in the REPORT and in the MONITOR of SAFEMASTER PRO DESIGNER.
Only if the validation is successful we will proceed to send the configuration.
Now the finished project must be verified. Execute the VALIDATE command (Icon
on the standard
toolbar)
The validation function only verifies the consistency of programming with respect to the characteristics of
the SAFEMASTER PRO system. It does not guarantee that the device has been programmed to meet all
the safety requirements for the application.
