Configurable safety system SAFEMASTER PRO - Fieldbus module
23
0265998 / 16.05.19 de / 101A
Operator can query module configuration at any time while the module is in use. To configure the modules
proceed as follows.
The configuration window is displayed:
5. Press the
"CONNECT"
button.
The program recognizes that a UG695x bus module is connected; the status bar shows the the UG695x fieldbus
model, the UG695x firmware version, the schematic CRC (3) and the Master status and firmware version:
• gray: the UG 695x is not connected
• orange: the UG 695x is getting/sending the configuration from the Bus configurator
• green: the master UG 6911 is active (RUN)
• red: UG 6911 is not active ((e.g. communication with SAFEMASTER PRO Designer)
Once the module is connected it is recognized and the operator can configure the parameters by selecting the
different areas as shown above; press the
WRITE
button to send the configuration data to the module.
As soon as the bus module receives the data, the configurator enters the monitor condition.
The input, output, analog data status and relative diagnostics are illustrated above. Only the first 16 input
diagnostics and output diagnostics are shown, if there are more than 16 diagnostics the exceeding one are
displayed after the previous one are solved.
The Fieldbus input logical status can be changed by the user only with the UG 6957 module they are in read only
mode für all the other fieldbuses and they'll display the status written by the external PLC.
GRAPHICAL USER INTERFACE
