3.2 Installing the CS128MH onto the CS128LF
Use the information provided in this section to install the CS128MH onto the CS128LF.
About this task
The following tools are needed to secure the Dolby CS128LF:
• 6 mm hex driver or wrench
Procedure
1. Remove the five M10 bolts from the top of CS128LF low-frequency cabinet.
2. Place the provided yoke onto the top of the CS128LF, and then reinstall the five M10 bolts (see Figure 9).
3. It is recommended to perform the horizontal aiming process at this point.
4. Fully tighten the M10 bolts.
Optionally, the M10 bolts can be loosely installed and tightened later as discussed in
on page 18.
Figure 9: Mount yoke to top of CS128LF low-frequency cabinet
5. Install the two M10 bolts supplied with the CS128MH mounting hardware bag into the two side mounting
locations on the CS128MH cabinet.
The bolts must remain loose enough to allow the cabinet to slide into the yoke as described in step 6 (see
the following figure for M10 yoke mounting locations).
Installing the CS128MH onto the CS128LF
Dolby Speaker System 128 Owner's Manual
17
8800293 Issue 2
27 October 2021
