Input
Drive. Crank it and drive the inbuilt distortion stage, turn it down for standard
tones. (not saved)
Foot-Switches:
Tap/Recall
When all the square switches are lit this is TAP tempo. When only the
Recall
square switch is lit,
Recall
is its function.
Hold down this switch for 2secs and it becomes the Recall switch, release
then press it once to recall position 1, 3 times for position 3 and so on. Leave
it for 2secs and your preset will load.
Hold it down for 2 secs and it will default back to Tap tempo.
Bypass
When the ENGAGED led is lit the effect is in circuit. When it
’s out
channel
one
is true bypass,
channel two
is buffered bypass.
Jacks:
In1 and In2
–
Check the
Config
section to see where each signal goes
Out1 and Out2
– Check the
Config
section to see where each signal comes from
CV in
Plug an external CV (LFO) into the Phaser. Link effects pedals, or sync with your
computer etc. (0-5VAC signal)
CV out
Use the powerful inbuilt CV (LFO) to run other effects or a synth LFO. Connect this
to the CV in on your synth with a standard Jack to Jack.
EXP1
Plug an expression pedal in to control the Rate
Recall
Connect the Dogmatek recall footswitch to recall the settings on all your Dogmatek
pedals easily.
DC
9VDC
