DOGA BA 100R, Instruction Manual

Page: 5 / 12

Instructions manual / BA…R arms series
5
2.2 Setting of the hand powered tool
Set the hand powered tool with the clamp as follows :
- Untighten the two screws with the suitable ALLEN wrench
-
Adjust the tool on the lower or upper side
-
Tighten slightly the two screws until a complete flanging of the tool
WARNING :
- A strong flanging of the tool can damage its good running
- A weak flanging of the tool won’t completely erase the torque reaction effect
3. BALANCER SETTING
Set the tension of the balancer according to the tool weight.
The balancer is properly set when the operator can handle the arm without any effort.
To increase the balancer tension force, turn the balancer wheel clockwise.
To decrease the balancer tension force, turn the balancer wheel counterclockwise.
IMPORTANT: Don’t forget to set the cable stroke with the black ball located on it.
4. ADVISINGS
- Do not overcome the maxi load and maxi torque mentioned on the arm.
- Necessary maintenance: after 150.000 cycles.
- Take into account the workstation coverage dimensions before installation.
- Tighten the base properly and make sure that the work station is stable.
5. SERVICING
After 150.000 cycles :
a) Dismount the sliding bush and the two chromed slides.
b) Clean the parts with a spray gun.
c) Clean the main pole and the two chrome slides with a dry rag.
d) Mount the arm again checking the right alignment of the two chromed slide and the proper tightening of
the clamp.
This servicing must be achieved as soon as the arm shrinks
6. MAINTENANCE
Must be achieved either by DOGA or the DOGA official distributor in your country.
Please keep this manual