Dog trace d-control 1020, User Manual

Page: 11 / 21

Button – lighting the collar
A red LED diode inbuilt in the collar emits very intensive fl ashes which are stronger than by
common light collars. Your dog can be easily located even in absolute darkness!
There are 8 interesting fl ashing modes available.
Mode Function
0 pressing shortly – single blink
1 pressing permanently – blinking as long as the button is pressed
2 pressing shortly – blinking 10times
3 after pressing – a blink in every 5 seconds
4 same function as mode 0 with a diff erent fl ashing frequency
5 same function as mode 1 with a diff erent fl ashing frequency
6 same function as mode 2 with a diff erent fl ashing frequency
7 same function as mode 3 with a diff erent fl ashing frequency
NOTICE: By modes 3 and 6 do not forget to switch off blinking by pressing the light
button. Modes 4–7 can be used for diff ering dogs in darkness.
Control buttons
These buttons are used for quick selection of impulse intensity from the receiving collar.
It is possible to set 30 levels, indicated by numbers 1–30 on the LCD display. When the preset
correction impulse level is changed, the LCD will be lit for 3 seconds.
Level 0: no impulse. Level 1: the weakest impulse. Level 30: the strongest impulse.
11
SETTING THE MODES:
Press a dog selection button 1 or 2 (depending on which button the required
receiver is paired) until symbol 1 or 2 starts blinking on the LCD.
Set the required mode number (0–7) using the correction impulse setting arrows.
Confi rm the selection by pressing button 1 or 2 again.
}