User's Guide
Wheel Electronic V1.0 and 2.0
Page 11
The following table shows the relation between the settings of the jumpers 5… 8 of JP1 and the
corresponding preset:
Jumper #
Midi function of ...
Preset
#
5 6 7 8 ST1 ST2 ST3 ST4 ST5
1
PIT
MOD
VOL
AT
SUST
2
PIT MOD VOL
BC (*)
SUST
3
VOL VOL+1 VOL+2 VOL+3 SUST
4
MOD
68
VOL EXP SUST
5
1/2 3/4 5/6 7/8
SUST
6
SUST SOST SOFT VOL SUST
7
8
9
10
11
12
13
14
15
16 PAN
EXP
VOL
BAL
SUST
5
= jumper installed
The factory setting is shaded grey (preset # 1).
Abbreviations:
PIT pitch
bend
AT
monophonic after touch
MOD
modulation (control change # 1)
BC (*)
breath control (control change # 2),
voltage range adapted to BC2 (+5...+2,5V)
VOL
volume (control change # 7)
BAL
balance (control change # 8)
PAN
panorama (control change # 10)
EXP
expression (control change # 11)
SUST
sustain (control change # 64)
SOST
sostenuto (control change # 66)
SOFT
soft pedal (control change # 67)
number
other controller (number = control change number)
Remarks:
•
Preset #1 is the standard preset for pitch bender, modulation wheel and two controllers for
volume and after touch.
•
Preset #2 is similar to preset #1 but after touch is replaced by breath control. The
WE
firmware has been adapted to the
Yahama BC2
. Provided that the BC2 is wired as
described on page 9 it generates a voltage in the range of +5V (no pressure) to ~ +2,5V
(maximum pressure), i.e. the behaviour is reverse (higher pressure
→
lower voltage) and the
voltage range is limited to about +2,5...+5V. In preset #4 connector ST4 has been adapted
to this reverse behaviour.
•
Preset #3 is planned to control the volume on four succeeding Midi channels. The Midi
channel selected by the jumpers 1...4 is valid only for ST1. ST2, ST3 and ST4 transmit their
volume data on the following Midi channels (marked by V+1, V+2, V+3).
•
Preset #4 is a special preset for the organ emulation B4 by Native Instruments. The control
change numbers 1 (actually modulation) and 68 are used to control the rotary speakers.
