DOEPFER
System A-100
Trigger-Sequenzer A-157-2/3
1
1. Introduction
The
Trigger-Output Module A-157-2
and the
Control-
Input Module A-157-3
are both required to drive the
Trigger Sequenzer A-157-1
:
The
Trigger-Out Module A-157-2
is where the trigger
signals (+12V) for each sequencer track can be tapped
from.
The
Control-Input Module A-157-3
is used to control the
sequencers run functions (start / stop / reset / clock). You
can either control them manually using the push buttons, or
by applying external signals of
≥
+3 Volts.
Please note:
To run the sequencer, an external clock signal
has to be patched to the
A-157-3
clock input socket. Please
refer to page 2.
2. A-157-2 Trigger Output Module
The
Trigger-Output Module A-157-2
is self explaining. The
eight sockets provide the trigger signals (+12V) for each
sequencer track.
IMPORTAND: Before installing
the modules A-157-2
and A-157-3 please read carefully the
setup
instructions on pages 3 and 4 !