Dodge Neon 2001, Service Manual

Page: 75 / 743

vides limited VTSS and power door lock functions,
but disables the Remote Keyless Entry (RKE) func-
tions. This mode is intended to be used when the
vehicle is on the dealer lot to provide VTSS coverage
of the vehicle while minimizing battery drain. Ship-
ping mode disables all normal functions (i.e. power
door locks, RKE, and VTSS) of the module, and is
intended to be used when the vehicle is shipped from
the assembly plant.
CHILD PROTECTION LOCKS
The lock is engaged by moving a lever that is
located on the rearward inside edge of the door.
To use the system, open each rear door and move
the control UP to engage. When the system on a door
is engaged, that door can only be opened by using the
outside door handle even if the inside door lock is in
the unlocked position.
WARNING: AVOID TRAPPING ANYONE IN A VEHI-
CLE IN A COLLISION. REMEMBER THAT THE REAR
DOORS CAN ONLY BE OPENED FROM THE OUT-
SIDE WHEN THE CHILD PROTECTION LOCKS ARE
ENGAGED.
NOTE: For emergency exit with the system
engaged, move the lock rocker switch rearward
(unlocked position), roll down window and open the
door with the outside door handle.
DECKLID SOLENOID
REMOVAL
(1) Disconnect and isolate the battery negative
cable (Fig. 1).
(2) Raise deck lid to the full up position.
(3) Unplug connector from solenoid.
(4) Remove two solenoid mounting screws.
(5) Remove solenoid from vehicle.
INSTALLATION
(1) Install the solenoid into the vehicle.
(2) Install the two solenoid mounting screws.
(3) Plug the connector into the solenoid.
(4) Close the deck lid.
(5) Connect the battery negative cable (Fig. 1).
Adjust the deck lid latch and striker so that the
deck lid latches with a moderate slam, and so that
the deck lid releases properly whenever the power
deck lid release is activated.
DECKLID RELEASE SWITCH
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Open the glove box door.
(3) Using a trim stick (special tool #C-4755) or
equivalent, gently pry out on the deck lid release
switch and pull out of instrument panel.
(4) Disconnect the wiring connector.
(5) Remove switch from vehicle.
INSTALLATION
(1) Connect the wiring connector.
(2) Align switch in hole and firmly snap into place.
(3) Close the glove box door.
(4) Connect the battery negative cable.
Fig. 1 BATTERY NEGATIVE CABLE REMOVE/
INSTALL
1 - NEGATIVE CABLE
2 - NEGATIVE BATTERY POST
8Ns - 4 POWER LOCKS
PL
POWER LOCKS (Continued)
ProCarManuals.com
2001 NEON