Dodge 2004 Ram 2500, Owner'S Manual

Page: 124 / 426

If you live in Canada or you are having difficulties
programming a gate operator by using the
9
Program-
ming
9
procedures (regardless of where you live), replace
(
Programming HomeLink
(
step 3 with the following:
NOTE: If programming a garage door opener or gate
operator, it is advised to unplug the device during the
9
cycling
9
process to prevent possible overheating.
3. Continue to press and hold the HomeLink button
while you press and release every two seconds (
9
cycle
9
)
your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. (The indicator
light will flash slowly and then rapidly.) Proceed with
9
Programming
9
step four to complete.
Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at: www.homelink.com or 1-800-355-
3515
.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be
9
reprogrammed
9
-
note below), follow the step noted:
•
Press and hold the two outer HomeLink buttons until
the indicator light begins to flash-after 20 seconds.
Release both buttons. Do not hold for longer that 30
seconds. HomeLink is now in the train (or learning)
mode and can be programmed at any time beginning
with
9
Programming
9
- step 2.
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE