Dodge 2004 Durango, Owner'S Manual

Page: 130 / 386

If the indicator light blinks rapidly for two seconds and
then turns to a constant light, continue with
(
Program-
ming
(
steps 6-8 to complete the programming of a rolling
code equipped device (most commonly a garage door
opener).
6. At the garage door opener receiver (motor-head unit)
in the garage, locate the
9
learn
9
or
9
smart
9
button. This
can usually be found where the hanging antenna wire is
attached to the motor-head unit.
7. Firmly press and release the
9
learn
9
or
9
smart
9
button.
(The name and color of the button may vary by manu-
facturer.)
NOTE: There are 30 seconds in which to initiate step
eight.
8. Return to the vehicle and firmly press, hold for two
seconds and release
the programmed HomeLink button.
Repeat the
(
press/hold/release
(
sequence a second time,
and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink should now activate your rolling code
equipped device.
NOTE: To program the remaining two HomeLink but-
tons, begin with
9
Programming
9
step two. Do not repeat
step one
. For questions or comments, please contact
HomeLink at www.homelink.com or 1-800-355-3515.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter sig-
nals to
9
time-out
9
(or quit) after several seconds of
transmission which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to
9
time-out
9
in the same manner.
130 UNDERSTANDING THE FEATURES OF YOUR VEHICLE