DOD TEC8G, Owner'S Manual

Page: 8 / 17

1) by pressing the Bank select footswitch followed by footswitch 1, 2, or 3.
2) by turning the Data wheel in Program mode.
To Select Programs using the footswitches:
1) After you power up, the TEC8G defaults to Program mode. Select a
Bank by pressing the Bank selector footswitch. The display shows the
selected bank number on the left side of the display and a dash on the
right. The display might look something like this:
or 2) Press footswitch 1, 2, or 3. The dash in the display
changes to show the number of the Program you
selected. The display might look something like this:
NOTE: If a new Program number is not selected within 5 seconds after
pressing the Bank select button, the display returns to its previous setting.
Editing Programs
As you become more familiar with the TEC8G, you may find that you need
to modify certain Programs to better fit your needs. Fortunately, the
TEC8G is flexible enough to give you everything you need without being
difficult to program.
The following procedure is an example of how to modify your
Programs. Suppose that Program 63 (which has an Arena
reverb, 250 ms Mono Delay, a Tremolo, Noise Gate, EQ, and
Compression) sounds close to what you want, but you want a
300 ms delay with low feedback instead. Here's how to change
it:
1) Use the Data wheel, or the Bank and Program selector
footswitches to select Program 63.
2) Press the Delay effect Group button. The Mono Delay Group
Status LED begins flashing and the display reads:
25
23
2_
6