SR606
DISTRIBUTION AMP
To use the SR606 as a distribution amp connect your source signal to either
the Left, Right, or Left and Right Inputs.
Connect as many of the 1 through 6 Outputs as desired.You may also use the
Left and Right Outputs for a total of 8 Outputs.
The signal coming in to the Left/Right Inputs will be delivered to the 1 through
6 Channel Outputs.
The Level control of each Channel will adjust the volume at each individual
Channel Output.
The Pan control of each Channel will select which Input (Left/Right) the signal
is being taken from.
The Master Output will only affect the signal strength at the Left/Right
Outputs.
In this mode the SR606 can be used as a mono in with six outputs, or a dual
mono in with as many outputs (up to 4 for each mono input) as you desire.
BUFFER AMP
To use the SR606 as a buffer amp, connect your source signals to as many of
the 6 Inputs as needed.
Connect as many of the 6 Outputs as needed.This should coincide with the
number of Inputs.
The Channel Level knobs will now attenuate, or provide up to a 4 dB boost in
gain to the signal(s) being sent to the corresponding Outputs.
MAINTENANCE AND SERVICING
There are NO user serviceable parts inside the units. Opening the chassis will
void the warranty. All service and repair must be performed by the factory or
an authorized service center for the warranty to remain in service.
Should a problem arise with the equalizer, please contact your authorized DOD
Electronics dealer for return/repair procedures.
5
