Never exceed the maximum weight and assembly force(15nm).You can find the
maximum weight for every specific ride in our manual.
3
)
应尽量避免暴露在阳光,水,沙堆,泥土等会造成其老化和缩短使用寿命的环境因素。
Avoid streets and Excessive exposure to sunlight ,water, sand, gravel, and
other debris that will shorten the life of the
docyke
.
4
)
应避免接近尖锐的物体,以免刮伤其表面,同时尽量在平缓的地区使用。
Avoid sharp bumps, drainage grates and sudden surface changes. Ride on smooth,
paved surfaces.
5
)
多可
由很多小零件组成,部分表面尖锐,请妥善保管并放置于儿童无法接触到的地方,
以免被幼儿误食或弄伤。
Before assembly
,
present a choking hazard to children under the age of three.
Care should be taken during unpacking and assembly to insure that all small
parts and plastic bags are accounted for and kept out of the reach of
children.
6
)
多可
不用时请放置在干燥的地方妥善保管。
Dirt
,
1eaves
,
and other debris can damage
,
shrink
,
expand or weaken
docyke
parts. Keep your ride in a dry environment.
7
)
多可
除螺钉外其余都为特别设计的零件,请不要和市场上类似零件混用。
Most of the docyke
’s components are
specially designed, please do not mix
with similar parts on the market.
8
)
检查充气轮胎气压不能大于
1.8bar(
1.8 kgf/cm²
)
Check the air pressure in the tires to max 1.8bar
9
)
适当着装,不要穿宽松衣物或饰品,让衣服,头发远离运动部件,避免卷入其中。
Dress properly. Do not wear loose clothing or jewelry. Keep your hair,
clothing and gloves away from moving parts. Avoid caught in moving parts.
10
)
佩戴好个人防护装置,安全装置后使用
多可
,如防滑鞋,安全帽,等。
Use personal protective equipment. Always wear protective equipment such as
non-skid safety shoes, hard hat etc.
11
)
在进行任何调节,更换附件或储存
多可
之前必须使电池与产品脱开,减少以外启动危
险。
Disconnect the battery pack from the DOCYKE before making any adjustments,
changing accessories, or storing DOCYKE.
电气安全警告:
阅读所有警告及说明!不遵照以下警告和说明会导致电击,着火或严重伤害!
Electrical safety warning:
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire or serious injury.
1
)
充电器仅中室内使用,并使充电及使用环境的清洁,干燥。不得暴露在潮湿,粉尘环
境中,否则会增加电击危险。
The recharge is only used indoors, Keep work area clean and well lit. Do
not expose DOCYKE to rain or wet conditions.
Summary of Contents for S-08
