Docomo F-04H, Instruction Manual

Page: 33 / 196

Before using the terminal
31
◆ Installing/Removing a docomo nano
UIM card
･
Install/remove after turning OFF the power.
･
Be sure to use the tray when inserting a docomo nano UIM
card. Failure to do so may cause a malfunction.
■ Installing
a
Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip (
a
)
b
Put your fingertip on the groove of the tray and pull it
straight out (
b
)
･
The tray is designed to be removed from the docomo
nano UIM card slot.
c
With the IC side facing up, place the docomo nano UIM
card on the tray (
c
)
･
Check the orientation of docomo nano UIM card corner
cut.
d
Make sure that the display side of the terminal is facing up,
then insert the tray straight into the docomo nano UIM
card slot (
d
)
e
Press firmly the slot cap of the terminal to close → P24
■ Removing
a
Face up the display side of the terminal and open the slot
cap hooking the groove with your fingertip
b
Put your fingertip on the groove of the tray, pull it straight
out, then remove the docomo nano UIM card
c
Make sure that the display side of the terminal is facing up,
then insert the tray straight into the docomo nano UIM
card slot
d
Press firmly the slot cap of the terminal to close → P24
a
c
d
b
Corner cut
IC
Tray
Groove
Slot cap