Docomo F-04H, Instruction Manual

Page: 26 / 196

Contents/Precautions
24
❖
What you can do with waterproofness of
F-04H
・
You can use the terminal to communicate without using an
umbrella in the rain with a rainfall of about 20 mm per hour.
- When your hands or the terminal are wet, avoid opening/
closing the slot cap.
・
The terminal can be washed with tap water at room
temperature.
- With holding the slot cap not to open, wash the terminal
with tap water without rubbing hard.
- Do not apply water flow stronger than allowed (
→
P22).
- Do not use brush, sponge, soap, detergent, etc.
- If mud or dirt has adhered to your terminal, shake it several
times in tap water put in a washbowl or other container to
rinse it off and then flush it with running water.
- Drain water in the specified steps (
→
P26) after washing.
・
You can use the terminal in a bathroom.
- Do not immerse the terminal into a bathtub. Also, do not
use the terminal in hot water. May cause malfunction. If
you should fall the terminal into the bathtub, immediately
pick it up to drain water in specified procedure (
→ P26).
- Never put the terminal in hot spring water or water
containing soap, detergent or bath powder. In case the
terminal gets wet with water other than tap water, wash it
in the procedure above.
- You can use the terminal within 2 hours in a bathroom
where the temperature ranges between 5 and 45
℃
and
humidity ranges between 45 and 99%.
- Rapid temperature change may cause condensation. If you
bring the terminal from a cold place to warm place such as
a bathroom, wait until the terminal reaches the room
temperature.
- Do not put hot water from a faucet or shower.
◆
To ensure waterproofness/dustproofness
To prevent water or dust from entering the terminal, be sure
to observe the following points.
・
When attaching or removing a docomo nano UIM card or
microSD card, put your fingertip in the groove and pull open
the cap in the directions indicated by the arrows (
a
). After
use, press it in the direction indicated by the arrows (
b
) and
close the cap securely in the direction indicated by the
arrows (
c
) while tracing it with a finger along. Ensure that
there are no gaps between the slot cap and the body.
a
b
c
Groove