INSTALL FIRMWARE
- download and extract
XIIO firmware
from www.doboz.audio
- install
Arduino IDE
and
CH341SER
driver to your computer
- install
FastLED
and
Adafruit MPR121
libraries
Arduino IDE > Sketch / Include Library / Manage Libraries
- open
XIIO_v2_firmware.ino
Arduino IDE > File / Open (Ctrl+O)
- remove Nano from module, connect it to your computer
-
select board
Arduino IDE > Tools / Board / Arduino Nano
-
upload sketch
by hitting the "Upload" button (or Ctrl+U)
- disconnect Nano from computer
STEP 6
PAGE: 05
CALIBRATION
- TURN ON YOUR SYSTEM AND LET IT WARM UP FOR 20 MINUTES
- SET OCTAVE MODE TO
LATCHING
AND OCTAVE ACTION TO
IMMEDIATE
- EXIT SETTINGS, HIT A NOTE PLATE, TUNE IT TO MINIMUM,
STEP DOWN TO THE LOWEST OCTAVE
- PLUG YOUR MULTIMETER INTO THE CV OUTPUT AND TUNE THE
ZERO
TRIMMER
SO THAT THE VOLTAGE READS AS CLOSE TO 0.000V AS POSSIBLE
- NOW TUNE THE CV OUTPUTS FOR
V/OCT
SCALING BY
STEPPING UP AND DOWN OCTAVES WITH
OCTAVE UP/DOWN
PLATES
STEP 7
