doble TDR9000, User Manual, Page: 399 / 454

TDR9000
™
Circuit Breaker Test System User’s Guide
72A-1898 Rev. A 11/01 G-5
Monday
, November 26, 2001 1:09 pm
Continue Test Conflicts
Table G.4 lists the message that appears once the test has begun to run,
but encountered an error. In this instance, once the conflict is resolved,
the test can continue.
Test Exceptions
Table G.5 lists the message that appears once the test has begun to run,
but encountered an error. In these instances, the test is aborted.
Table G.4 Continue Test Conflicts
Error Message
There must be an external trigger plug connected in order to run an
externally triggered test. Remove the safety switch and insert the
external trigger plug.
Table G.5 Test Exceptions
Error Message Solution
There must be a safety switch
connected in order to control the
circuit breaker under test. Connect a safety switch and rerun
test.
Test was aborted because the
safety switch was released before
the test was completed. Run test again, pressing safety
switch until tones ceases.
Test aborted by host.
General Data Acquisition System
error during test run. Run Self-Diagnostics (see
”Self-Diagnostics Test”
on page B-1).
Safety switch not pressed within 2
minutes. Test was aborted. Run test again, pressing safety
switch until tones ceases.
Trip overload during test run. See ”Test Exceptions Procedure”
on page G-7.
Close overload during test run. See ”Test Exceptions Procedure”
on page G-7.