DoAll C-8056SA, Instruction Manual

Page: 20 / 26

18
6 MACHINE REPAIR AND MAINTENANCE
6.1 QUALIFICATION OF MACHINE PERSONNEL
MACHINE MAINTENANCE PERSONNEL: The person must have enough knowledge of
machinery and have been well trained.
ELECTRIC MAINTENANCE PERSONNEL: The person must have enough knowledge of
electronics and have been well trained.
6.2 MACHINE REPAIR
During operation, the machine may suffer from damage caused by personnel or other factors. In
case of any abnormal motion occurs, the operator needs to perform trouble shooting. If the
problem cannot be corrected, contact an experienced service technician for trouble shooting
assistance.
※
CAUTION: Except for experienced maintenance personnel, do not dismantle any parts of the
machine without authorization to do so.
6.3 MACHINE MAINTENANCE
The machine must be operated under normal conditions and maintained periodically to upgrade its
performance and life.
The table below gives instructions for routine checks of the machine.
ROUTINE CHECK ITEMS FOR THE MACHINE
CHECK CYCLE CHECK ITEMS
DAILY
1. Pressure gauge on hydraulic systems.
2. Coolant amount.
3. Steel brush condition.
4. Check if the saw blade is properly located on the right and left saw
wheel and between the front and rear tungsten plates.
WEEKLY
1. Check oil amount in hydraulic power unit.
2. Check lubrication oil amount in gearbox.
3. Shoot grease to the parts below:
※
Tension slide
※
Driven wheel
※
Gear box base
4. Remove deposited chips under the chip collection tank.