- 18 -
English
CHARGING THE BATTERY
The integrated battery comes partially charged. No damage occurs to the camera
or battery if used before being fully charged.
Connect the DC 5V power source by using the supplied USB cable to the camera‘s
DC 5V socket.
The Status LED lights red during charging.
Mounting the Camera
Loosen the Phillips screws in the mounting buckle and attach it to the saddle post.
Tighten the screws carefully.
After this step the camera can be attached to the mount using its quick-release lock.
Follow the instructions printed on the back of the camera.
Rotate the camera 90° clockwise and insert the pin on the back into the mount ope-
ning marked with an arrow.
After this step rotate the camera 90° counterclockwise and lock the camera in its
mounting.
Now your BikeCamHD is ready to use.
Connecting the Cable Remote
Using the cable remote is optional.
Route and fasten the cable alongside the bicycle frame.
Fasten the remote button to the handlebar with cable ties.
The cable remote works in both USB sockets of the camera.
Please make sure that all components are securily fastened to the bicycle
frame using the cable ties that come with the product.
Connecting the Dynamo Charging Cable
A charging cable is supplied with the camera to charge the battery on the move.
Route the cable alongside the bicycle frame to the dynamo.
There are 2 wiring options: one-wire and two-wire connection.
Getting Started
bikecamHD-170x125-1.indd 18
bikecamHD-170x125-1.indd 18
22.06.2017 13:35:04
22.06.2017 13:35:04
