ST600-KIPRO User Manual
Page
7
of
16
5. CONNECTION TO KI PRO
1.
Using a Web browser, enter the IP address of the ST600-Kipro panel to access the
configuration pages.
2.
Select the Remote Device Assignment link located on the left hand side of the web
page.
3.
In the Remote Device Assignment page, create a device label for the AJA KIPRO you
will be connecting to.
4.
In the “Device type” column, select “KIPRO” from the dropdown menu.
5.
In the “Connection type” column, select “TCP” from the dropdown
menu
6.
In the “Connection Mode” column, select “Client Transmit/Receive”
from the dropdown menu.
7.
In the “IP Address” column,
enter the IP address of the Ki Pro. Next
under “Port Number”
set the Port number
to “80”
.
8.
P
ress “Save”
to save your changes.
The ST600-KiPro communicates over IP to AJA KiPros using the KiPros's native control
protocol.
The native control protocol does not provide a means to synchronously roll multiple
units.
As a result, transport commands are sent to each KiPro, one at a time.
There will be a
delay between KiPros based upon inherent IP network delays and each KiPro's command
processing delay after receiving the command.
