5
5
4000CL-LPH, 400 Clip Fast Access System, Louth Phillips Protocol
4. VIDEO
SERVER
SETUP
a.
Select LOUTH Broadcast communications protocol on the VIDEO SERVER to be
controlled.
b.
If required, assign a serial port on the VIDEO SERVER through which the ST300 will
control it.
c.
The VIDEO SERVER may not support LTC or VITC time modes in LOUTH Broadcast
mode. The ST300 will default to Tape Time if a non-supported time mode is selected on
the ST300.
NOTE
:
In LOUTH mode, the VIDEO SERVER may
O
NLY
allow Full Record.
INSERT and ASSEMBLE record modes may be disabled.
The Video Server does
not
support search to a time location using Timecode
(LTC or VITC) in LOUTH Protocol. Tape Time mode (TM) must be selected on the ST300.
Setup is complete.
5.
LOAD AND PLAY CLIPS USING THE ST300
a.
LOAD AND PLAY A CLIP USING THE ST300
1) Press
[
CLIPLIST
] to view the list of Clips that exist in the VIDEO SERVER.
The display will show “CREATE NEW CLIP”.
2)
Turn the wheel. The top line of the display will show “xxxxxxxx:”
Where “xxxxxxxx” is the eight character CLIP ID.
Turn the wheel clockwise to scroll forward through the list of available CLIPs
Turn the wheel counter-clockwise to scroll back through the last 10 CLIPs
previously viewed.
3) Press
[
LOAD
] to load the current CLIP ID shown on the top line of the display.
b.
LOAD AND PLAY A CLIP FROM THE SHOTLIST
On the ST300
1)
Select a Cue Point in the Shotlist:
Press [
NEXT CUE
] or [
LAST CUE
] to step forward or step backward through
the SHOTLIST.
OR
Enter a 1-, 2- or 3-digit number on the numeric keypad, followed by [
ENTER
].
The contents of the selected Cue Point are shown on the bottom line of the
display.
2) Press
[
LOAD
] to load the CLIP ID shown on the bottom line of the display.
3) Press
[
PLAY
] to play the clip.
