5
6
7
a b c
a b c
8
9
a
a
M
Before adding the windows
H
above the gates, you will
need to glue the transparent film
J-L
onto them.
This ensures a greater satability.
Glue the windows in their respective positions. The ones above
the gates must be aligned with the top of the supports.
The gates are build up using three parts. The centre part is
more narrow then the outer ones. When glueing these parts
make sure they align to the inside of the gates, leaving a small
recess to the outside. This is where you add the 0,5mm wire,
making sure it extends about 1-2mm to both top and bottom of
the gate.
If you want to enlarge the space between the bottom of the
gate and the base of the roundhouse, you should do this now
(= trimming back the bottom).
It is best to lay the roundhouse back down on your workbench
when proceeding with this step:
Insert the gate into hole (
a
) in the base.
When the gates are in their correct position, glue the beam
M
to the front above the gate.
a
b
c
GATE TOPVIEW
< INSIDE OUTSIDE (SUPPORT) >
You can now glue the roof to the roundhouse.
However, if you want the roundhouse to remain
accessible, you should just add the roof without glueing it.