Before used
Charging the Battery as follows:
1. The attached USB Cable a type side connected in to the PC USB connector and the
Micro USB plug side connected in to the Bluetooth Speaker.
2. The Red LED will light on during charging.
3. When charging completed the Red LED go off.
Power On and Power Off the Bluetooth Speaker
1. Press the ON/OFF switch to ON and wait for about 5s a
n alert tone will “Di” and then
Blue LED flash 5 times ,”du”, ”du” then enter the Pairing mode and the Red and Blue
LED will fast blink alternately
2. Press the ON/OFF switch to OFF to power off the power.
Pairing the Bluetooth Speaker with a Mobile Phone
Make sure your mobile phone is Bluetooth-enabled. Specific pairing steps may vary with
different cell phones. Refer to the User Guide for your mobile phone for further information.
The general pairing steps are as follows:
1. Keep the Bluetooth Speaker close to your mobile phone.
2. Press the ON/OFF switch to ON and wait for the unit entered the Pairing mode when
the Red and Blue LED will fast blink alternately
3. Search the Bluetooth Device under the pairing mode in the mobile phone.
4.
Once the search is completed, the “
BTi20
” will show in the Bluetooth device list.
5.
Selected the “
BTi20
” to connect and entering the matching code with “
0000
”.
6. The pairing will completed at the moment and the Blue LED of the Bluetooth Speaker
will blink two times every 5S.
Notes:
If pairing is not successful, Switch Off the Bluetooth Speaker and then redo the
pairing procedure again.
If pairing is successful, the paired devices will remember each other. Unless the pairing
information is deleted because of a new pairing, there is no need to go through the pairing
procedure again when using the same devices the next time.
