DMP Electronics XTLtouch Series, Installation Manual, Page: 13 / 20

Digital Monitoring Products | XTLtouch Installation Guide 10
ADDITIONAL INFORMATION
SECONDARY POWER SUPPLY
The XTLtouch’s 800 mAh rechargeable standby battery is used to provide four
hours of battery power when DC power is not available. The battery is intended
for back power only and should not operate the panel on a daily basis.
If the battery is low or not plugged into the battery connector, a low battery
condition is indicated by the panel. If a 24 hour standby battery is needed,
connect a 4800 mAh battery.
Replace the Battery
1. Remove the backplate from the XTLtouch.
2. Unplug the battery and remove it from the base.
3. Place the new battery in the same location and secure it with the included
adhesive. See Figure 9.
4. Plug in the new battery.
5. Replace the backplate.