3
X1-8 QUICK START GUIDE | DIGITAL MONITORING PRODUCTS
DETERMINE COMMUNICATION
This section only applies to the X1 Door Controller.
For more detailed information, follow the QR code at the end of this guide to see
the full X1-8 Installation and Programming Guide: LT-2289.
Ethernet Connection
Connect an Ethernet cable from the LAN/
WAN connection to the X1 Ethernet port.
Cellular Connection (Optional)
1.
Attach the included standoff to the
Door Controller.
2. Plug the Cell Module onto the standoff.
3. Plug the Cell Module into the Cell
Header.
4. Attach the Cell Module Antenna cable
to the antenna connector.
5. Run the cable around the 505-12
Power Supply.
6. Attach the antenna with the nut on the inside of the enclosure and the
washers on the inside and the top of the enclosure.
Wi-Fi Connection
If not connecting over Ethernet, the Door Controller will connect over Wi-Fi after
power up.
For installing the Wi-Fi Antenna, follow the QR code at the end of this guide to
see the full X1-8 Installation and Programming Guide: LT-2289.
Note:
You can connect over Ethernet or Wi-Fi, but not both at the same
time.
APPLY POWER
This section only applies to the X1 Door Controller.
Warning:
Refer to your local state regulations before connecting to building
power. Wiring methods shall be in accordance with NEC, NFPA72, ANSI, and
with all Authority Having Jurisdiction.
Ground the System
Be sure to secure the green wire lead to an earth ground. Connect to a cold water
pipe, ground rod, or building ground when available. Connection to an electrical
ground or conduit can also be used. Gas pipes or sprinkler pipes should not be used.
Connect AC Power
Connect an unswitched 120 V AC 60 Hz power source to the transformer leads
on the 505-12. Remove desired knockouts for power input.
Wire the Battery
The battery leads for the X1-8 come pre-wired.
Ethernet
Port
PoE
Headers
Cell
Header
Standoff
Location
