DMP Electronics ITI 738I, Installation And Programming Manual

Page: 11 / 24

Digital Monitoring Products, Inc. | 738I ITI™ Installation and Programming Guide 7
PROG Header
When programming the 738I, connect the provided Model 330 programming cable (with
two 4-wire connectors) from the PROG header to any DMP thinline, wireless, or graphic
touchscreen keypad.
PROGRAM Header
1. Place the provided jumper across the PROGRAM header to enter 738I
programming mode.
2. After programming, remove the jumper from the header and place it over one pin
for future use.
Model 738I
BLK
RED
BLK RED BLK RED
PROG Header: Use Model 330 Programming
Harness to DMP Keypad for programming
DMP Bus Header: Use Model 300 4-Wire
Harness to DMP Keypad Bus or LX-Bus
Receiver Header: Use Model 300 4-Wire
Harness to ITI Receiver
A
B
C
D
A B
C
D
PROGRAM Header
Figure 2: 738I Connection