iCom Series Universal Alarm Communicator Programming and Installation Guide
Digital
Monitoring
Products
29
SET LOCKOUT CODE
SET LOCKOUT CODE
Press CMD at the stop option to display SET LOCKOUT CODE. This feature allows you to
program a special code that will be required to gain access to the communicator’s internal
programmer through the keypad.
Changing the Lockout Code
You can change this code at any time to any combination of numbers from 1‑5 digits long
(1‑65535). Do not use leading zeros for the lockout code.
1. Press any select area. The keypad displays ENTER CODE: ‑ .
2. Enter a 1‑5 digit code and press CMD.
Note
: Do not enter a number higher than 65535.
3. Enter the new lockout code you just entered in the keypad and press CMD.
The keypad displays CODE CHANGED.
Once you have changed the code, it is important that you write it down and store it in
a safe place. Lost lockout codes require the communicator to be sent back into DMP
for repair. You may cancel a lockout code by entering 00000 at the set lockout code
command option.
SET LOCKOUT CODE
