1
2
3
4
DESCRIPTION
1
INSTALL THE PANEL MODULE
Caution: Touch grounded metal to discharge static before handling the
panel.
1. Open the panel enclosure and remove all power from the panel.
2. Insert the standoff provided with the cell modem into the
XT30/XT50 or XR150/XR550 Series panel standoff hole.
3. Align the 263EXT standoff hole with the standoff already placed
in the panel. Secure the 263EXT on the 12-pin cell module
header. See Figures 3 and 4.
4. Place the module on the panel.
With the 263EXT Cellular
Extension Modules, you can now
maintain dB signal over
greater distances. The 263EXT
comes with two modules. The
panel module (see Figure 1) installs
directly on the panel inside the
enclosure while the remote module
(see Figure 2) installs with the cell
modem at the remote location that
provides the best signal.
The modules communicate with
each other through a wired
connection, maintaining dB
signal even from higher or lower
locations. Use CAT5 wire with
T568B Wiring to connect the
two modules. If using anything
other than CAT5 wire, it should
be 22 AWG shielded wire with the
shield connected to the ground
terminal on both the panel side
module and the remote side
module. The 263EXT has a reach
of up to 300 feet.
Compatibility
The 263EXT is compatible with
panels that have a 12-pin cell
module header, such as the
following panels:
• XT30/XT50 Series panels
• XR150/XR550 Series panels
What is Included
• 263EXT Panel Module
• 263EXT Remote Module
Standoff and
Standoff Hole
Back of the 263EXT
Figure 3: 263EXT Panel Module on an XT30/XT50 Panel
Figure 4: 263EXT Panel Module on an XR150/XR550 Panel
Back of the 263EXT
Standoff and
Standoff Hole
Figure 1: 263EXT Panel Module
Figure 2: 263EXT Remote Module
263EXT CELLULAR EXTENSION MODULES
Installation Guide
