1100XHE ENCRYPTED HIGH POWER
WIRELESS RECEIVER
Installation Guide
1
WIRE THE 1100XHE
2
MOUNT THE 1100XHE
Select a Location
When selecting a location to mount the 1100XHE, keep in mind
that the receiver should be centrally located between the
1100 Series transmitters used in the installation. The 1100XHE
can be mounted up to 500 ft (150 m) from the panel using
22 AWG or 1000 ft (300 m) using 18 AWG. Be sure to mount
the receiver away from large metal objects because it may
impair the receiver’s performance. Do not use shielded wire
between the panel and receiver.
Mount the 1100XHE
1. Remove the cover from the plastic housing.
2. Use the included #6 screws to secure the 1100XHE to
the wall. See Figure 2 for mounting hole locations.
Connect the red, yellow, green, and black wires to the
PANEL
terminal on the 1100XHE and connect the other to the
XBUS
terminal on the panel. See Figure 2.
Note:
The receiver can’t operate if it’s connected to the
keypad bus.
PROGRAM THE PANEL
RF RX
RF TX
PANEL RX
PANEL TX
WALL
TAMPER
ENABLE
DISABLE
STATUS
PWR
Figure 1: 1100XHE
Encrypted High Power
Wireless Receiver
Refer to the panel programming guide as needed.
1. Reset the panel.
2. At a keypad, enter
6653
(PROG) to access the
PROGRAMMER
menu.
3. In
SYSTEM OPTIONS
, program a
HOUSE CODE
between
1 and 50. See
House Code Explained
for more information.
4. At the
1100 ENCRYPTION
prompt, select
ALL
to only add
encrypted wireless devices to the system. Select
BOTH
to
allow both encrypted and non-encrypted wireless devices
to be programmed.
5. The default passphrase appears at
ENTER PASSPHRASE
.
Press
CMD
to keep the default. Press any select key or
area to change the passphrase and enter an 8-character
hexadecimal string (0-9, A-F).
6. In
ZONE INFORMATION
, enter a
ZONE NAME
and press
CMD
.
7. Select the
ZONE TYPE
and press
CMD
.
8. At
NEXT ZN?
, select
NO
.
9. Select
YES
when
WIRELESS?
displays.
10. Enter the eight-digit
SERIAL#
and press
CMD
.
11. Enter the
SUPRVSN TIME
and press
CMD
.
12. At the
NEXT ZN?
prompt, select
YES
to finish
programming or select
NO
for additional programming
options.
3
DESCRIPTION
The 1100XHE Encrypted High Power
Wireless Receiver provides up to
100 wireless zones for XR150 Series
panels and up to 500 wireless
zones for XR550 Series
panels. The 1100XHE features
128-bit AES encryption.
The 1100XHE provides two-way,
supervised communication using
900 MHz frequency hopping-
spread-spectrum technology.
The 1100XHE contains additional
transmit and receive amplifiers to
enable 1100 Series operation at
greater distances or harsh building
environments. The additional gain
introduced by this amplification
may inhibit proper communication
with 1100 Series transmitters
located within 4 ft of the receiver.
This distance may be 8 ft when
using the 1122 PIR or 9000 Series
Wireless Keypads.
The 1100XHE is equipped with a
case and wall tamper.
Compatibility
•
XR150/XR550 Series Panels
•
Encryption requires panel
Version 183 or higher
What is Included?
•
One 1100XHE Encrypted
High Power Wireless
Receiver
•
Hardware Pack
