INTERMEDIATE ADJUSTABLE
CRIMP
T
OO
L
.
MH860 (M22520/7-01)
,,,. ...... DANIELS
-..,,
MANUFACTURING
w,
CORPORATION
DATASHEET
THIS HAND TOOL MUST NOT BE USED IN ANY POWERED
"PRESS" AS DEFINED BY OSHA CFR 1910.211 (46)
SEE REVERSE SIDE FOR IMPORTANT INFORMATION CONCERNING
LIMITED WARRANTY, AND LIMITATION OF LIABILITY.
GENERAL INFORMATION:
1. Designation MH860 (M22520/7-01) refers to basic tool without positioner.
2. Wire crimp range 16 to 28 AWG
3. The tool has a double action ratchet, and cannot be opened without completing the cycle.
INSTALLATION OF POSITIONER:
1. Tool must be in open position.
2. Remove safety clip from positioner guide.
3. Select correct positioner for contact to be crimped.
4. Insert positioner into positioner guide. Push down and turn 90 degrees until bayonet pins lock.
5. Wire size and corresponding selector numbers are shown on the dataplate.
6. With tool in open position, remove spring clip then raise and rotate selector knob until number indicated on dataplate
wire size to be crimped is in line with the Sel. No. arrow.
CRIMPING INSTRUCTIONS:
1. Insert contact and prepared wire through the indenter opening into the positioner.
2. Squeeze handles together until ratchet releases. Handle will return to open position.
REMOVING POSITIONER:
1. Push down on positioner to release bayonet pins from positioner guide. Turn 90 degrees and remove from tool.
� SAFETY CLIP
SPRING CLIP
SELECTOR KNOB
POSITIONER GUIDE
TOOL IN CLOSED
POSITION
DATAPLATE
POSITION ER
'86' SERIES
DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA, PHONE 407/855-6161, FAX 407/855-6884
COPYRIGHT© 2016 DANIELS MANUFACTURING CORP., USA. WWW.DMCTOOLS.COM E-MAIL: [email protected] ALL RIGHTS RESERVED
MARCH 2016
REV. E
MH860-DS
