HDE51C-DS
©2022 DANIELS MANUFACTURING CORP., ALL RIGHTS RESERVED
Page 7 of 8
REV. A
7/26/2022
Daniels Manufacturing Corporation
526 Thorpe Road, Orlando, FL 32824 USA
Phone: 407-855-6161 Fax: 407-855-6884 Email: [email protected]
HDE51C
BATTERY POWERED CRIMP TOOL
DATASHEET
TOOL INFORMATIONAL DISPLAY
When a battery is installed onto the tool, the following
information can be accessed.
Install a charged battery onto the tool.
1.
Press the tool trigger to activate the display. Any
applicable error codes will be display. The 17 possible
error codes are listed below. If an error code is
displayed, the tool’s red LED will also flash.
2.
The first screen will display whether tool is connected via
Bluetooth, the battery charge level, current pressure &
max pressure.
3.
Pressing the left button once will display the firmware
version, and tool serial number.
a.
Pressing the left button again displays the
current user.
b.
Pressing and holding both button lets you
c.
select a current user.
d.
Use the right button to select the desired user.
e.
Press the tool trigger to confirm selection and
return.
4.
Pressing the left button once again will display the
number of cycles and days until the next service interval.
5.
Pressing the left button once again will display the total
operating hours, total Amp Hours (Ah) and the total
number cycles.
6.
Press the right button will allow you to go back to the previous
screen.