COPYRIGHT © ALL RIGHTS RESERVED
3
REV. B
3/99
FILE # DS0076
DOC. # DCT4-119-DS
DCT4-119
DATA SHEET
3. All pins, pivot points, and bearing surfaces should be
protected with a thin coat of any good SAE No. 20
motor oil. Do not oil excessively.
4. When the tool is not in use, keep the handles closed
to prevent objects from becoming lodged in the crimp-
ing jaw. Store the tool in a clean, dry area.
Periodic Inspection:
Regular inspections of the tool should be performed by
quality control personnel. A record of scheduled inspec-
tions should remain with the tool or be supplied to super-
visory personnel responsible for the tool. Inspection fre-
quency should be based upon the amount of use, working
conditions, operator training and skill, and established com-
pany standards.
Visual Inspection:
1. Make certain that all retaining pins are in place and
secured with retaining rings.
2. Close tool handles until ratchet releases and allow
them to open freely. If they do not open quickly and
fully, the spring is defective and must be replaced.
3. Inspect the tool frame for wear or damage, paying
particular attention to the tool jaws and pivot points.
If tool is acceptable, lubricate and return to service.
4. Check the crimping dies occasionally to make sure
dies are not broken or chipped.
ADJUSTING RATCHET:
The ratchet adjustment is preset at the factory. If adjust-
ment is necessary, contact the factory for instructions.
DIE INSTALLATION:
Install die set into tool frame as shown in Figure 1. Install
and tighten retaining screws making sure dies are aligned
and fully seated against tool frame.
CONSULT FACTORY FOR OTHER DIE
CONFIGURATIONS
DMC P/N
DCT4-101
DCT4-102
DCT4-103
DCT4-104
DCT4-105
DCT4-106
DCT4-107
DCT4-108
DCT4-119
DCT4-121
DESCRIPTION
AMP STD. & MOISTURE RESISTANT CAPS
R/B/Y INSULATED TERMINALS
SLIDE ON R/B
HEAT-N-SEAL R/B/Y
UNINSULATED TERMINALS
.052 SQ./ .128 HEX/ .178 HEX
.068 HEX/ .178 HEX/ .324 HEX
.068 HEX/ .213 HEX/ .255 HEX
R/B/W SPLICES
.039 SQ./ .195 HEX
LIMITATION OF LIABILITY / LIMITED WARRANTY*
DANIELS MANUFACTURING CORPORATION IS NOT LIABLE FOR CONSEQUENTIAL OR SPECIAL
DAMAGES OF ANY NATURE OR KIND RESULTING FROM THE USE OF ANY OF ITS PRODUCTS. OWNERS
ANDUSERSOFDMCPRODUCTSASSUMEFULLRESPONSIBILITYFORINSTRUCTINGTHEIREMPLOYEES
IN THE PROPER AND SAFE USE OF SUCH PRODUCTS.
Daniels Manufacturing Corporation warrants each new unit sold by it to be free from defects in material and
workmanship under normal use and service. Its obligation under this warranty is limited to the free correction or, at its
option, the refund of the purchase price of any such unit which proves defective within ninety (90) days after delivery to
the first user, provided that the unit is returned to it with all transportation charges prepaid, and which shall appear to its
satisfaction, upon inspection by it, to have been defective in material or workmanship. This warranty shall not cover any
damage to such products, which in the opinion of Daniels Manufacturing Corporation, was caused by normal wear,
misuse, improper operation or accident. This warranty is in lieu of all other warranties express or implied. No warranty,
express or implied, is made or authorized to be made or assumed with respect to products of Daniels Manufacturing
Corporation, other than that herein set forth.
*as defined by PL93-637
DanComm 4
TM
TOOLS