DM&P Group eBox-4300, User Manual

Page: 20 / 27

eBox-4300
12
T
ROUBLESHOOTING
This section describes the techniques of resolving some basic problems that you
encounter when using your VESA PC. For more troubleshooting guidelines, please
contact your nearest dealer for technical support.
T
ROUBLESHOOTING
Y
OUR
VESA PC
A. VESA PC does not start
Make sure the VESA PC is properly secured and plugged into a power source
before it is turned on. Make sure the power indicator shows the power is on. See
section 2 for more information about “eBox-4300 Overview”.
When the VESA PC is plugged into a power strip or the UPS (Uninterruptible Power
Supply), make sure the power strip or UPS is turned on and working normally.
Check if your VGA or LCD monitor is properly plugged into a power source and
turned on. Make sure the brightness and contrast controls are adjusted correctly.
See the manual that came with your display (monitor) for details.
Check if your power control button does not function, by removing the AC adaptor.
Wait for one minute, and then reattach all power connection before pressing the
power button.
Condensation may cause the VESA PC to malfunction for a while. If this happens,
do not use the VESA PC for at least one hour.
When you have checked all the above guidelines and the VESA PC does not work.
Remove the power adaptor from the VESA PC, unplug the power cord, and plug it in
again. Then turn on the power.
B. BIOS Error Message –
BIOS error message appear when my VESA PC starts
If the BIOS error message appears, press any key to resume or, hit <DEL>to enter
BIOS setup main menu, follow these steps:
1.
Press <DEL>, and the BIOS Setup main menu appears, check if HDD is detected
at “Pri Master”. If it is not detected, use “Sel” keys <
↑↓ > to choose “AUTO” and
then go back to the main menu by pressing <ESC>. Move your cursor down with
“Sel” keys <
↓ >, and choose “Save Settings and Exit”, a message dialog appears
as seen below, hit <Enter>.
“Save current settings and exit (Y/N)? Y”
2.
Go to “Auto Configuration with Optimal Settings” using the “Sel” keys < ↑↓ >, then
press <Enter>. A message dialog appears as seen below, hit “Y” key and press
<Enter> to save and recover the factory setting.
“Load high default settings (Y/N)? N”
8