Determine the vanity placement and mark the area
on the wall where it will be installed. Check that the
wall is straight, not bowed or twisted. Ensure vanity
is square against the wall before securing. Drawer
alignment could be affected otherwise.
Re-install drawers and adjust if necessary. Refer to
page 3 for instructions.
Vanity Cabinet Installation
01.
03.
04.
05.
06.
07.
09.
08.
02.
Vanity will have wall brackets pre-installed. Remove
screws from brackets and vanity. Take brackets to
mark proper measurement of vanity wdith and to wall
studs. If the studs do not line up to the mounting lo-
cation for your vanity, wood bracing can be installed
between the studs using standard 2 x 4’s behind the
finished wall. This should be performed by a qualified
licensed trade professional.
Use long screws supplied to drill screws into marked
locations.
All soft-close drawers must be removed before
installation. Proceed to page 3 for instructions.
Attach the vanity to the wall by screwing through the
vanity gable into the wall studs.
Lift cabinet over top of brackets and re-install screws
previously taken out to tighten vanity into place.
Choose the positioning of hardware of your choice
(not included) on the vanity cabinet. Mark the screw
hole location. Drill the cabinet with appropriate size
bit to accommodate the screw diameter. Install your
chosen hardware. Do not overtighten.
SIDE VIEW
2
WALL STUDS
VANITY GABLE
BRACKETS
ENSURE PROPER
MEASUREMENT
36" single
30" single
Follow instructions for SINK & COUNTERTOP
INSTALLATION if using a DM BATH Countertop and
Sink. If using a custom top and sink, follow Manufacturer
installation.
For DM BATH VESSEL SINK & COUNTERTOP
INSTALLATION, proceed to page 4.
For DM BATH UNDERMOUNT SINK & COUNTERTOP
INSTALLATION, read COUNTERTOP INSTALLATION
PRECAUTION on page 4 and proceed to page 5 for
installation.