
ASAP
®
REPAIR
PROUDLY MADE IN THE USA. // CAGE CODE: 7CFK2 // DUNS #: 079751064 // SBA 8(A) CERTIFIED // © 2021 DLX ENTERPRISES LLC
Cut patch 1 inch beyond all edges of the tear. If using more than one patch, overlap at least
1 inch. Trim and round corners.
Peel back 1/2 inch of paper liner.
Position exposed edge - allowing the patch to extend 1 inch beyond all edges of the tear. Peel
back the liner while applying the patch over tear. Follow steps 1-3 on the back side of the repair if
you have access to the backside.
Turn the material over so that the adhesive side of the tab is facing up.
Position reinforcement filament tightly against the outside edge. The filament should be
perpendicular to the open end of the tear to create a tough solid edge.
Fold over the patch’s 1 inch tab and rub to adhere to the backside of the material.
Apply another patch to the backside of the patched tear (so that both sides of material are
patched). Rub the entire patch aggressively.
NOTE: HEATING IS AN OPTION AND NORMALLY NOT NEEDED UNLESS TEMPERATURES ARE BELOW FREEZING.
1
2
3
4
5
6
7
Tear on Edge
Fold 1 inch Tab Over Filament
Apply Leaving 1 inch Tab Beyond Edge
Apply Reinforcement Filament
Apply to Back Side
Cut Filament to Width of Patch
Repairing tears extending through and outside edge
GENERAL SETUP
Follow steps 1-3 with the following adjustments:
- Cut the patch size to extend a full 1 inch beyond the edge of the torn material
- Peel and stick, positioning the patch with a 1 inch tab beyond the outside edge of the torn material