The amplifier include
RCA inputs
High Level input
Variable low pass crossover
Subsonic filter
Grand bass feature 0 - +18 dB
Phase shift continously variable 0-180 degr.
Remote bass level and phase shift control
Remote turn on / off
Automatic remote turn on/ off on high level
input without connecting any remote wire
Built-in cooling fan
Electronic protection circuitry against
short-circuit, DC offset and thermal overload.
Installation
Before you begin installation
Before you begin you need to read the manual, to have
some tools, cables and other material available. There
is one such list of material on the following page.
Amplifier location
Important
Allow air circulation around the amplifier.
2
Disconnect Battery
Before starting the instal-
lation, always disconnect
the negative terminal of
the battery.
The DLS Reference series of amplifiers have a
compact design that allows great flexibility in
mounting. You can mount it under a seat or in the
trunk. When you select a location, do remember
that the amplifier generates a lot of heat.
Choose a location where air can circulate freely
around the amplifier. Do not cover the amplifier
with carpets or hide behind trim panels.
Do not mount the amplifier in an inverted or upside
down position.
The amplifier has a built-in fan
in the bottom plate. Mount the amplifier on
spacers to allow the air to circulate inside the
amplifier.
Check all locations and placements carefully
before making any cuts, drilling any holes or ma-
king any connections.
This is the best direction to
mount the amplifier in order
to get the best cooling.
RA10
RA10
1 x 300 Watt RMS in 4 ohm load
1 x 5000 Watt RMS in 2 ohm load
1 x 780 Watt RMS in 1 ohm load
All above RMS power ratings at 13,8 Volt DC
RA10 is a mono amplifier for subwoofer use only.
The frequency range is limited to frequencies
between 10 Hz and 125 Hz.
DLS logo on amplifier cooling flange
The DLS logo on top of the amplifier is attached
with two hex. screws. The logo can be removed
and twisted 90 or 180 degrees, and then screwed
back in wanted position. The logo can be mounted
in four different ways to match your installation.
