Important
Use either the low level or the high level input, do
not use both at same time.
Low level input
Use a pair of shielded stereo audio cables with RCA
type jack. Most trunk-mount amplifiers need a 20
feet RCA cable ( appr 5 – 6 meters). Most under
the seat installations require
12 feet ( 2 – 3 meters) RCA
cables. Avoid placing the RCA
cable close to speaker cables,
power cables and remote
control cable. Connect to in-
put socket A & B.
High Level Input
Connect left and right speaker wires coming from
the car stereo to the high level input as shown. You
must connect both plus and minus as the inputs
are balanced, connecting plus only gives lower level
and bad sound quality. By changing the polarity of
plus and minus, you can change the phase.
Hi level input plug on amp.
Automatic turn on when using high level input.
With the Hi/Low input swich set to Hi, the amplifier turns
on automatically on high input. You dont need to connect
a separate remote wire from your head unit.
When using High Level input:
Set the switch to position ”Hi / Level”
When using Low level input:
Set the switch to position ”Low / Level”
If the switch is set to wrong
position, the amplifier still
works, but the risk for
disturbances or distortion
increases.
Input and controls
5
Input Level control
Subsonic filter
The
Subsonic filter
blocks
the very
deepest frequencies from reaching the
subwoofers. It has a variable
frequency from 15 to 50 Hz. A typical
setting is 25-30 Hz.
Low Pass Filter
The LPF ( low pass filter ) allow low
frequencies only and blocks higher
frequencies. A typical setting is 60 – 80
Hz. Choose the setting that sounds best
in your car.
Phase control
The phase control can be set
continuously from 0 - 180 degrees. This
is very useful when you want to adjust
the bass sound for best front stage
image.
Start at 0 and turn the control slowly
clockwise until you experience the bass
sound coming from the front.
You may have to change the polarity of
the speaker connection to get the best
result.
High Input
White
: Ach.+
White/Black
: A ch.-
Grey/Black
: B ch.-
Grey
: Bch.+
Input Wiring
Inputs may be low level from the RCA output of the car
stereo or high level from the car stereo speaker
output.Low level = RCA is to prefer for the best sound
quality.
Subsonic
15Hz 50Hz
LPF
15Hz 150Hz
The input level control, 5V – 0,15 V,
matches the output of your radio to the
input of the amplifier. After installation
is complete, make sure the input of the
amplifier is turned down all the way (
counter-clockwise at 5V ). Play a tape
or CD, make sure all bass or treble
settings or equalizer are flat, and turn
the volume of the radio up until you
just start to hear distortion. Turn the
volume control down just a bit. On the
amplifier increase the input level control
( clockwise or to the right ) until you just
start to hear distortion, then back the
level control just a bit. Now your radio
and amplifier levels are matched.
Level
5 V
0,15 V
Phase
0
o
180
o
Hi / Level
Low / Level
12
12
12
12
12
12
12
12
12
CAD 15
CAD11, CAD15