REM (Remote Trigger)
This terminal must be connected to a sw12V-
source.Typically, remote turn -on leads are provided at the source
unit that will turn on and off the amplifier in correspondence with the source. If the source unit does not have a remote turn-on
lead, then a sw12V supply must be used, like the ACC, +12V
Run a minimum of 18 gauge wire from the amplifier location to the source of the sw12V lead. If possible, route this
wire on the same side of the vehicle as your power cable. Connect the source remote output to the wire. Go back to the amplifier
and cut the wire to length. Loosen the screw terminal marked REM on the amplifier using an Allen wrench. Insert the stripped
(bare) portion of the wire into the terminal and tighten the screw securely
.
NOTE:
It is highly recommended that an Hex wrench is used to tighten the
set screws in the terminal blocks by hand and NOT a power drill. This will
prevent stripping or other possible damage to the amplifier.
Amplifier features specially tooled sorderless terminals for power (Batt +),
ground , remote and speaker connection. For maximum transfer of
voltage and signal the bare wire needs to be inserted as far as possible
into the terminal before tightening the set screw.
Hand tighten the set screw and make sure the connection is secure to
prevent possible arcing due to loose screws.
Summary of Contents for DD Series
Page 19: ......
