Settings
Use the remote control, press the
”DISP EDIT”
button and step through the following settings:
Balance – Input Level – Software Version – Edit Input Name – IR Input Front (not in use)
– Software Version – Back to Normal Display Mode (Input and Volume).
NOTE:
If you do not push any button within 3 seconds, the amplifier will leave the setting mode.
Balance
Input Level
Software Version
Edit Input Name
IR Input Front
Not in use
NOTE:
The AMPLIFIER ONE is equipped with a non-volatile memory that will remember all of the
settings you have edited, (Volume, Input selection, Alias names, etc.) that you used before placing
the unit into standby mode or switched the unit off totally by the mains switch.
Adjustment for Left and Right channel level.
Press
”Vol+”
to increase Left channel, or
”Vol-”
to decrease Right
channel.
To change the input level, select the input you wish to change, then
step through the menu by pressing
”DISP EDIT”
until
INPUT LEVEL
is shown in the display To adjust the input sen si tiv ity, simply press
”VOL+”
to increase the input sensitivity, or
”VOL-”
to decrease the
sensitivity When the desired level is set, exit the menu by pressing
the
”DISP EDIT”
button until your input name is displayed again, or
wait a few seconds. Your new level is now stored in the memory You
may store a different level for each input as they are stored indepen-
dently in the memory If you do not wish to use this feature, leave as
is, the inputs are factory preset to level ”0” (max +9, min -9).
Displays the software version.
The display uses maximum 8 character (of totally 14) to show Input
Name in the display
.
Select the Input you want to change by using the
”/- ”
buttons. Press the
”DISP EDIT”
button to activate the menu and
step until
EDIT INP NAME
is shown in the display Press
EDIT INP NAME
EDIT INP NAME
”VOL +”
and you will see the first character of your previously selected input
name flash. Use
”VOL +/ -”
to change the character. Go to the next
character by using the
”/-”
button. Then use the
”VOL
+/-”
to change the character, etc.
To exit the menu, press
”DISP EDIT”
until the new name is dis-
play ed or wait a few seconds.
5
