Rev 1.7 (April 2018) 6
¤
DLP Design, Inc.
6.3
TEST MODE:
For CW Mode - With Modulation - FLRC Mode
6.3.1
Press Button 1 until FLRC Mode is selected:
6.3.2
Press and hold Button 3. While holding Button 3, press and release RESET. Continue to hold
Button 3 until you hear a beep. Release Button 3 and the system will be transmitting at 2.4GHz on
the internal chip antenna with FLRC modulation.
6.4 TEST MODE:
For CW mode - With Modulation - GFSK Mode
6.4.1
Press Button 1 until GFSK mode is selected:
6.4.2
Press and hold Button 3. While holding Button 3, press and release RESET. Continue to hold
Button 3 until you hear a beep. Release Button 3 and the system will be transmitting at 2.4GHz on
the internal chip antenna with GFSK modulation.
6.5 PAIRING
Each Nucleo board has a unique serial number that is created by combining wafer data stored in
silicon within the STM32 microcontroller. This serial number is generated after each reset, and is then
presented on the LCD display of the DLP-RFS1280ACT. Pairing is the process of sending that
unique serial number to another DLP-RFS1280ACT so that the two devices are linked for all product
demonstrations that require two transceivers.
6.5.1
Press and hold Button 4. While holding Button 4, press and release RESET. Continue to hold
Button 4 until you hear a beep. Release Button 4 and the LCD will display “wait” to indicate that the
paired device’s ID data is forthcoming.
