4
Step 1: Close the Choke and turn on the ignition, advance throttle to full position.
（2）用力转动螺旋桨，
（最好用启动棒）直到发动机发出爆炸声.发动机会运转1-2秒而
自动熄火.（首次启动或长时间不用可能需要转动多次螺旋桨）
。
Step 2:, briskly flip the prop through compression until the engine fires and then dies. It
may take a few more flips if this is first time to start the engine after being stored for a
long period.
（3）打开风门，油门开至怠速或比怠速稍大一点,启动发动机，进入正常工作状态。
Step 3: Open the choke and briskly flip the prop through compression, advance the
throttle to very slightly above the idle position, the engine should start in just a few flips.
（4）热车启动：打开风门，油门开至怠速或比怠速稍大一点，直接启动发动机。
Step 4: pen the choke, advance the throttle to very slightly above the idle position, turn
on the ignition and briskly flip the prop through compression.
四、发动机的保养
(MAINTENANCE OF THE ENGINE)
1、请使用清洁的93＃汽油，和机油的比例为30：1；禁止不同厂家、牌号的润滑油
混合使用，否则将会引起化油器严重阻塞。
Please use the petrol 93
＃
. The ratio of petrol and engine oil is 30:1
；
Do not mixed up
different brand of engine oil, carburetor could be seriously blocked
2：发动机的磨合：4000 rpm/min.磨合2小时。发动机长时间低速运行，可能导致火
花塞积炭严重。
Breaking-in at 4000RPM/min for 2 hours. Running at low speed for too long might
carbonize the spark plug.
3、随时检查油箱至化油器之间的管路，不许有漏气情况。
Always check the tube at fuel system, make sure there is no air leaking.
4、请特别注意：在一定周期内清洁化油器里面的燃油滤网，否则将引起油针调节失
灵，发动机工作不稳等情况。
取下该螺钉
清洗过滤网
(Remove the screw）
（Clean the filter)
NOTICE: The carburetor fuel screen should be cleaned periodically also. Carefully
remove the pump cover (inlet side of the carburetor), gasket and pump membrane. The
screen will be visible and can be cleaned after careful removal.
联系我们/
Contact us
电话
(TEL)
：
4001006090
传真
(FAX)
：
086-0873-6131518
销售 (
Sale): 086-13529826090
Http
：
：
地址：中国云南省弥勒市弥勒工业区弥阳工业园
邮编：
652300
Address: MiYang Industrial Park
Mile Industrial District Mile City, 652300, Yunnan
Province, PR China
弥勒浩翔科技有限公司
Mile HaoXiang Technology Co.,Ltd
